Electrolux Laundry & Kitchen Appliance Repair in Temple, TX
Electrolux sells front-load laundry and kitchen appliances a step above its Frigidaire line, which the same company owns. Electrolux appliance repair in Temple, TX most often means a front-loader stopping with a drain or door lock code, a dryer taking too long or a refrigerator warming up.
Free callCall, choose the appliance, and enter your ZIP code.
- Free to call
- Technicians across Bell County
- All major appliance brands
- Temple & Bell County
Electrolux
Electrolux repair in Temple.
The Electrolux line usually sits higher up the range: front-load laundry with steam cycles, counter-depth refrigerators and ranges with convection and air fry. In Temple it turns up most in remodeled kitchens and in laundry rooms with stacked front-load pairs, and underneath, many models share platforms and parts with Frigidaire.
Electrolux model numbers start with E. Current front-load washers start with ELFW and dryers with ELFE (electric) or ELFG (gas); older laundry starts with EFLS or EIFLS. Kitchen appliances from the earlier Electrolux ICON and Wave-Touch lines start with EI or EW. Labels often carry three numbers: the model, a product number code (PNC) used for parts on some models, and the serial. A photo of the full label avoids ordering the wrong part.
Appliances
Electrolux appliances in Temple homes.
- Electrolux washer repairELFW and EFLS front-load washers, including steam and stacked laundry models
- Electrolux dryer repairELFE electric and ELFG gas dryers
- Electrolux refrigerator repairFrench door, side-by-side and counter-depth
- Electrolux freezer repairUpright and chest freezers
- Electrolux oven & stove repairElectric, gas and induction ranges, and wall ovens
- Electrolux dishwasher repairBuilt-in dishwashers
Common problems
Common Electrolux problems and what they usually mean.
General patterns, not model-specific defects.
Front-load washer will not drain or unlock
A clogged pump filter behind the small front access door is the most common cause, followed by a failed drain pump or door lock. Electrolux codes come in families: the E10s usually point to water fill, the E20s to draining and the E40s to the door lock. Clean the filter first.
Washer smells or leaves residue
Front-loaders hold moisture in the door gasket and dispenser. Too much detergent, or the wrong kind, makes it worse. Wipe the gasket, leave the door open after loads and run a cleaning cycle. If water is leaking, the gasket or a hose may need replacing.
Dryer takes too long or runs cold
A restricted vent is the first suspect, then the heating element, thermal fuse or thermostats on ELFE models, or the igniter and gas valve coils on ELFG models. Moisture sensor bars coated with dryer-sheet residue can end cycles early or late, and a quick wipe with a little rubbing alcohol often helps.
Dryer drum squeaks or scrapes
Like Frigidaire, many Electrolux dryers ride on front drum glides and rear rollers. Worn glides let the drum scrape the front panel. A glide kit is a routine repair.
Refrigerator or freezer running warm
Fans, the defrost system and dusty condenser coils come before the compressor. Electrolux was part of a 2022 ice maker recall alongside Frigidaire, so check your model at cpsc.gov if the ice maker is involved.
Before you call
What to have ready when you call.
With the Electrolux model number and the symptom in hand, the right parts are more likely to arrive on the first visit.
Checklist
- A photo of the full label: model number, PNC and serial number.
- Any error code on the display.
- For washers: whether you have cleaned the pump filter, and which detergent you use.
- Gas or electric (ELFE or ELFG on dryers).
- Whether the appliance is still under Electrolux’s warranty.
| Appliance | Usually found |
|---|---|
| Refrigerator | Inside the fresh-food section on the wall, visible when the door is open |
| Chest freezer | On the left outside wall, above the access panel |
| Range | On the side trim inside the oven door opening, the left side panel, or the storage drawer frame |
| Dishwasher | On the inside edge of the door or the side of the tub |
| Front-load washer | On the trim around the door opening, or behind the pump filter door on some models |
Locations vary by model. Source: Electrolux support: where can I find my model and serial number?
How it works
From call to Electrolux repair.
- Step 1
Call the line
Pick the appliance type for your Electrolux, then enter your ZIP code.
- Step 2
Describe the Electrolux
Read out the Electrolux model number, what it is doing and any code on the display.
- Step 3
Diagnosis first
Ask the technician to confirm what failed on the Electrolux before you approve a repair.
FAQ
Electrolux repair questions.
Is Appliance Repair Temple linked to Electrolux?
No. It is not affiliated with or authorized by Electrolux or Frigidaire. Appliances still under Electrolux’s warranty should go to Electrolux first.
Are Electrolux and Frigidaire parts the same?
Many are, since Electrolux owns Frigidaire and the two share platforms. Some trim, controls and features are Electrolux-specific. The full model number shows exactly which parts fit.
My Electrolux front-load washer will not drain. What can I check?
Switch it off, put a towel down and open the small access door at the bottom front. Drain the water through the hose if there is one, then clean the pump filter. If it still will not drain, the pump or a hose needs a closer look.
What is the PNC on my Electrolux label?
The product number code is an identifier Electrolux uses for some models and their parts. If your label has one, read it out along with the model and serial number.
Can a stacked Electrolux washer and dryer be repaired in a closet?
Usually, yes, though the dryer may need to come off the washer for some repairs. Clear the doorway and mention the stack on the call so the technician comes prepared.
What will an Electrolux repair cost?
No prices are listed here, since the cost depends on the appliance and the part. Ask the provider about the price and any warranty on the work before agreeing to it.
Electrolux acting up? Call the line.
Have the Electrolux model number and any code in front of you, then describe what the appliance is doing.
Call, choose the appliance, and enter your ZIP code.
- Free to call
- Technicians across Bell County
- All major appliance brands
- Temple & Bell County
Free call
Call Appliance Repair Temple
(254) 615-2088Call, choose the appliance, and enter your ZIP code.
- Say which appliance it is, the brand and what it is doing.
- Your call goes to a technician who works in your area.
- Settle the timing and the price before any work starts.
Urgent leak or no cooling? Say so when you call.